Canon MP730 Uživatelský manuál stáhnout pdf

Unpack the machine and its components.

Check that you have the following:

NOTE

•A printer cable is not included.You must purchase a USB cable (less than 16 # / 8 ft./5 m) to

connect your machine to a computer.

Machine Multi-purpose tray Tray cover

Document tray

Printhead

Ink tanks

(Black, cyan, magenta, yellow)

Paper output tray

Power cord

Documentation

(Set-Up Sheet, Quick Reference Guide)

MultiPASS MP730/700 Setup CD-ROM

Telephone line cord

Destination labels

Set-Up Sheet

Thank you for purchasing the Canon MultiPASS MP730.

To get your machine ready for use, please follow the instructions in this Set-Up Sheet

before referring to any other documentation.

READ THIS SHEET FIRSTREAD THIS SHEET FIRST

• DO NOT assemble the machine or connect the USB cable

before installing the software. You will be instructed when

to assemble and connect the cable.

IMPORTANT

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Set-Up Sheet

Unpack the machine and its components.Check that you have the following:NOTE•A printer cable is not included.You must purchase a USB cable (less than

Strany 2 - Install the software

NOTE•When installing the software in Windows 2000/XP, you must log on as Administrator orhave Administrator privileges.•If you have previously install

Strany 3 - Assemble the machine

8 Follow the on-screen instructions.9 Click [Finish].IMPORTANT• Proceed to step below to assemble the machine.Please keep your computer powered on.Rem

Strany 4 - Connect the power cord

Connect the telephone line and any necessary external device,and set the receive mode.NOTE• Before using your machine, you need to makesure it is set

Strany 5 - Install the printhead

Load paper.Place a stack of paper (print-side up) in the multi-purpose tray q.Pinch the paperguide A and adjust to the width of the stack w.Then place

Strany 6 - Install the ink tanks

3 Raise the lock lever C, then gently slide the printhead into the holder.Lower the lock lever.IMPORTANT• Do not lift the lock lever once the printhea

Strany 7 - Align the printhead

Align the printhead.NOTE• You can also align the printhead from the software.For details, refer to the Software Guide.1 When the LCD A displays the fo

Strany 8

Connect the USB cable to complete the computer settings.1 Make sure the machine is turned on.2 Connect the USB cable A to the machine and computer USB