Canon XA25 Uživatelský manuál stáhnout pdf (Strana 15)

The XA25 Setup Page 15

Water Alarm (Optional)

If you have the optional water alarm installed there are three alarm conditions to know:

Condition LED Siren

New Battery

(Insertion)

Bright Intense blink while

siren plays

Ascending tones played 4 times

Water Intrusion Bright Intense Blink Warble sound. Alarm will sound for

duration of detection.

Low Battery Low Intensity fast blink Descending tones played 8 times

pausing approx. 20 seconds between

plays after alarm test or water detection.

The alarm can tested anytime by shorting the detection contacts that lead to the water

alarm transducer. The water detection condition will activate for 6 seconds. If the battery

is drained the low battery condition will sound.

The water alarm requires a single 6V battery like Radio Shack model 23-469 or A544.

Your battery should be removed when stored (e.g. between dive trips). Check the

battery prior to every dive to ensure proper operation. Change when indicated.

 CAUTION: You must wait a minimum of 30 seconds between battery insertions to

allow the unit to fully discharge.

Inside rear shell showing the Water

Alarm battery.

Water Alarm siren

Water Alarm LED

will indicate here.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Žádné komentáře

Canon XA25 Uživatelský manuál Strana 15