Canon XA25 Uživatelský manuál stáhnout pdf (Strana 10)

The XA25 Setup Page 10

Installing the Camera into the Housing

 Pull out Manual, Custom and Assign Controls. The manual and custom control

need only be retracted ~ 1in / 2.5cm

 Carefully insert the camera into the front housing half as shown.

 Observe that the camera mates to the camera tray for alignment.

 Secure the camera by tightening the thumbscrew firmly.

 Open the LCD fully as shown in the image on the next page. If necessary, gently

press it into the receiver on the left side of the housing.

 Press in the Manual, Custom and Assign Controls.

 Insert the Canon IR Remote into the housing as on the next page.

 Check controls. At this point it’s a good idea to check all controls on the front shell

for proper operation. (See section 4 for controls mentioned here.)

Align the camera to the

housing and mount tray, then

tighten the thumbscrew firmly.

Insert the camera into

the housing as shown.

Pull out the Manual,

Custom and Assign

Controls

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Žádné komentáře

Canon XA25 Uživatelský manuál Strana 10