Canon Mk2500 Uživatelská příručka stáhnout pdf (Strana 116)

2

 Inputcharacters.

Input “A-123”, press [▼], and then input “R11”.

Perform the printing operation.

•

Only 1.3mm double-byte characters can be set to three lines.

The maximum number of printable characters depends on segment length setting.

•

If you wish to increase the number of printable characters

When “Normal” is selected on the Plate Printing Area selection display, spaces are

automatically inserted at the left and right of the print. When “Expansion” is selected, the

printing area expands all over the segment length without inserting any space.

If you wish to adjust the segment length

For how to adjust the printing result finely, refer to Note, “Adjusting the segment length”

( page 101).

 

Printingresultobtainedbyspecifyingacharacteralignmentmodeandamultiplelinecenteringmode



The printing result varies depending on the choice of a character alignment mode and a multiple line centering

mode.

Input characters

1st line: A-123

2nd line: R11

Case 1

Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2 mm/1-byte, Number of lines = 2 lines,

Character alignment = Centered, Multiple line centering = On

A-123

R11

Case 2

Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2 mm/1-byte, Number of lines = 2 lines,

Character alignment = Centered, Multiple line centering = Off

A-123

R11

Case 3

Cut length = 30 mm, Plate Printing Area = Normal, Character size = 2mm/1-byte, Number of lines = 2 lines,

Character alignment = Left/2 mm

A-123

R11

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 157 158

Žádné komentáře

Canon Mk2500 Uživatelská příručka Strana 116