Canon imagePROGRAF iPF8100 Uživatelský manuál Strana 749

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 814
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 748
Cannot print over a network
Cannot print over a network
Cannot connect the printer to the network
Cause Corrective Action
The Ethernet cable is not connected
correctly to the printer s Ethernet port.
1. Make sure the printer is connected to the network with the correct
Ethernet cable, and then turn the printer on. For instructions on
connecting the cable, refer to the Quick Start Guide .
2. Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100
Base-TX and orange if connected via 10Base-T .
If the Link indicator is not lit, check the following points.
Make sure the hub is on.
Make sure the end of the Ethernet cable is connected
correctly .
Insert the Ethernet cable until it clicks and locks in place.
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
Check the communication mode with the hub.
Although the printer normally detects the hub
communication mode and transmission rate automatically
(in auto negotiation mode), sometimes the hub settings
cannot be detected. In this case, congure the connection
method manually , specifying the communication mode in
use. ( P .736)
T roubleshooting 735
Downloaded from ManualsPrinter.com Manuals
Zobrazit stránku 748
1 2 ... 744 745 746 747 748 749 750 751 752 753 754 ... 813 814

Komentáře k této Příručce

Žádné komentáře