Canon DR-6080 Uživatelský manuál

ENGLISHPUB.CE-IE-422G 0704AB0.6 CANON ELECTRONICS INC. 2003 PRINTED IN JAPANCANON ELECTRONICS INC.1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892

877Cleaning the Guide Plate (When Using the Imprinter)Ink that collects on the guide plate inside the optional imprinter may stain thedocuments when t

88Chapter 7 Daily CleaningReplacing the RollersThe feed rollers (pickup rollers, feed rollers, and retard rollers) are consumables.The feed rollers ne

897Resetting the CounterDo the following procedure to reset the counter after replacing the feed rollers.1 Click the [Start] button, and then click [S

90Chapter 7 Daily Cleaning3Select the scanner that you are using, and click on the [Properties]button.4Click the [Counter] tab.5Click the [Reset] butt

917Installing and Removing the RollersFollow the procedure shown below to remove and install the rollers when youneed to clean or replace the pickup,

92Chapter 7 Daily Cleaning◆ Installing and Removing Pickup Rollers1Open the upper scanner.2Open the roller cover.3 Open the roller holder and remove t

9375 Firmly close the roller holder until you hear it click.6 Firmly close the roller cover until you hear it click.7 Carefully close the upper scanne

94Chapter 7 Daily Cleaning◆ Installing and Removing Feed Rollers1 Open the upper scanner.2 Open the roller cover.3 Pull the lever that locks the feed

9575 Remove the feed rollers.6 Place the new feed rollers on the pin.7 Set the feed rollers in place (q), and align the notch in the roller’saxle with

96Chapter 7 Daily Cleaning8 Lock the lever.9 Firmly close the roller cover until you hear it click.10 Carefully close the upper scanner.If the roller

Chapter 7Daily CleaningThis chapter describes daily cleaning of thescanner.7.1 Daily Cleaning ... 80Cleaning the Main

977◆ Installing and Removing Retard Rollers1 Open the upper scanner.2 Remove the roller cover.3 Lift the roller clamp lever (q) and slide it to the le

98Chapter 7 Daily Cleaning4 Move the retard rollers to the left and remove them.5 Set the new retard rollers in place, and align the notch in the roll

9977 Pull the lever towards you to clamp the retard rollers in place.8 Put back the roller cover.9 Carefully close the upper scanner. Be sure that th

80Chapter 7 Daily CleaningDaily CleaningTo ensure high-quality image scanning, regularly clean your DR-6080/9080C asdescribed below. Before you clean

817Cleaning the Document Detection SensorDust and debris that collects on the sensor will cause false recognition. Clean thesensor periodically so tha

82Chapter 7 Daily Cleaning4Use a clean, soft cloth to wipe the scanning glasses.Be sure to clean both scanning glasses, the one below and one above.Ne

8375Wipe the rollers with a firmly wrung cloth moistened with water.Rollers are located at the positions indicated in the figure below.Feeding Rollers

84Chapter 7 Daily Cleaning8Replace the rollers that you removed. (See “Installing andRemoving the Rollers,” on p.91.)9Carefully close the upper scanne

857Cleaning the Shading PlatesIf scanned images appear scratchy even after you have cleaned the rollers, theshading plates inside the scanner may be d

86Chapter 7 Daily Cleaning4Press the [Stop] key.The shading plates retract.5Carefully close the upper scanner.6Press the upper scanner down firmly on